URL: https://flybefore.com/glossary/
Last updated: 2026-11-15

# RC and ArduPilot glossary

Last updated November 15, 2026 · By the [Fly Before team](https://flybefore.com/about/)

Short definitions of the words RC pilots, builders and ArduPilot users use every day, from aileron to QuadPlane. Most entries link to a guide where the term matters.

[Aileron](#aileron) · [Elevator](#elevator) · [Rudder](#rudder) · [Throttle](#throttle) · [AETR](#aetr) · [TAER](#taer) · [CG](#cg) · [Stall](#stall) · [Stall speed](#stall-speed) · [Wing loading](#wing-loading) · [Thrust-to-weight ratio](#thrust-to-weight) · [Expo](#expo) · [Dual rates](#dual-rates) · [Trim](#trim) · [Failsafe](#failsafe) · [RTL](#rtl) · [FBWA](#fbwa) · [MANUAL](#manual) · [LOITER](#loiter) · [AUTO](#auto) · [QHOVER](#qhover) · [QLOITER](#qloiter) · [QRTL](#qrtl) · [QLAND](#qland) · [QuadPlane](#quadplane) · [Tilt-rotor](#tilt-rotor) · [Transition](#transition) · [SITL](#sitl) · [MAVLink](#mavlink) · [Ground control station](#ground-control-station) · [QGroundControl](#qgroundcontrol) · [Parameter](#parameter) · [OSD](#osd) · [RSSI](#rssi) · [Link quality](#link-quality) · [EdgeTX](#edgetx) · [USB joystick](#usb-joystick-hid) · [Maiden](#maiden) · [Dead-stick landing](#dead-stick) · [Crosswind](#crosswind) · [Thermal](#thermal) · [Kv](#kv) · [mAh](#mah) · [C rating](#c-rating) · [ESC](#esc) 

**Aileron**
Hinged surfaces on the trailing edge of the wings that move in opposite directions to roll the plane. Right stick right raises the right aileron and lowers the left.

**Elevator**
The hinged surface on the horizontal tail that pitches the nose up or down. Pulling the stick back raises the elevator and the nose.

**Rudder**
The hinged surface on the vertical tail that yaws the nose left or right. Used for coordinated turns, crosswind corrections and ground steering.

**Throttle**
Controls motor power. On a radio the throttle stick stays where you leave it; on most gamepads it springs back.

**AETR**
A channel order: aileron on channel 1, elevator on 2, throttle on 3, rudder on 4. The default on EdgeTX and OpenTX radios. [More](https://flybefore.com/guides/edgetx-usb-joystick-mac/)

**TAER**
A channel order with throttle on channel 1, then aileron, elevator, rudder. The default on Spektrum radios. A simulator expecting AETR will put the sticks in the wrong places until you remap them. [More](https://flybefore.com/guides/spektrum-ws2000-mac/)

**CG (center of gravity)**
The balance point of the plane. Build manuals give a CG range measured from the wing&#x27;s leading edge. A tail-heavy CG is a classic cause of maiden crashes. [More](https://flybefore.com/guides/maiden-flight-checklist/)

**Stall**
When the wing&#x27;s angle of attack is too high for the airflow to stay attached, lift drops suddenly and a wing or the nose falls. Recovery: release back pressure, add power, level the wings. [More](https://flybefore.com/learn/)

**Stall speed**
The slowest speed at which the plane can fly level. It rises with weight and in turns. Fly Before&#x27;s Workshop shows it as the Slow flight gauge. [More](https://flybefore.com/workshop/)

**Wing loading**
Weight divided by wing area, often in oz/ft² or g/dm². Higher wing loading means a faster stall speed and a faster landing.

**Thrust-to-weight ratio**
Static thrust divided by flying weight. Around 1:2 cruises gently; above 1:1 a plane can climb vertically. Fly Before&#x27;s Workshop shows it as the Power gauge. [More](https://flybefore.com/workshop/)

**Expo (exponential)**
A radio setting that softens stick response around center while keeping full throw at the ends. If set in the radio, a simulator reading the radio as a joystick sees the curved output. [More](https://flybefore.com/guides/radiomaster-tx16s-mac/)

**Dual rates**
A switchable reduction of maximum control throw, for example 60% on low rates. Low rates are common for maidens and for beginners.

**Trim**
Small offsets to the neutral position of a control so the plane flies straight and level hands off.

**Failsafe**
What the receiver or flight controller does when the radio link is lost: hold, cut throttle, or in ArduPilot switch to a mode such as RTL. Set it and test it before the first flight. [More](https://flybefore.com/ardupilot/)

**RTL (return to launch)**
An ArduPilot mode that climbs to a set altitude, flies back to the home position and circles overhead. [More](https://flybefore.com/ardupilot/)

**FBWA (fly by wire A)**
An ArduPilot plane mode in which the sticks command bank and pitch angles within limits, and the plane levels itself when you let go. Throttle stays manual. [More](https://flybefore.com/ardupilot/)

**MANUAL**
An ArduPilot mode that passes your stick inputs straight to the servos with no stabilization.

**LOITER**
An ArduPilot plane mode that circles around a point at the current altitude.

**AUTO**
An ArduPilot mode that flies the uploaded mission: waypoints, takeoff, landing and other commands. [More](https://flybefore.com/guides/qgroundcontrol-mac-simulator/)

**QHOVER**
An ArduPilot QuadPlane mode that hovers on the lift motors, holding height while you control position by hand. [More](https://flybefore.com/vtol/)

**QLOITER**
A QuadPlane mode that hovers and holds position using GPS. [More](https://flybefore.com/vtol/)

**QRTL**
A QuadPlane return-to-launch mode that comes home and lands vertically. [More](https://flybefore.com/vtol/)

**QLAND**
A QuadPlane mode that descends and lands vertically where it is. [More](https://flybefore.com/vtol/)

**QuadPlane**
ArduPilot&#x27;s name for fixed-wing aircraft that also have lift motors for vertical takeoff and landing. The QuadPlane code handles hover, transition and forward flight. [More](https://flybefore.com/guides/quadplane-simulation-without-hardware/)

**Tilt-rotor**
A VTOL layout in which some motors tilt from vertical, for hover, to horizontal, for forward flight. [More](https://flybefore.com/vtol/)

**Transition**
The change from hover to wing-borne forward flight, or back. The aircraft must build enough airspeed before the wing can carry it. [More](https://flybefore.com/guides/vtol-transition-practice/)

**SITL (software in the loop)**
Running the real autopilot firmware as a program on a computer, with a simulator supplying sensor data and receiving servo outputs. [More](https://flybefore.com/guides/ardupilot-sitl-on-mac/)

**MAVLink**
The messaging protocol ArduPilot and PX4 use to talk to ground stations, companion computers and other tools.

**Ground control station (GCS)**
Software for monitoring and commanding an autopilot: maps, telemetry, missions and parameters. QGroundControl and Mission Planner are examples.

**QGroundControl**
A free, open-source ground control station for ArduPilot and PX4 that runs on macOS, Windows, Linux, Android and iOS. [More](https://flybefore.com/guides/qgroundcontrol-mac-simulator/)

**Parameter**
A named setting stored in the autopilot, such as RTL_ALTITUDE. ArduPlane has well over a thousand. Ground stations read and write them.

**OSD (on-screen display)**
Flight data drawn over the FPV video: battery, altitude, speed, mode, home arrow and warnings. [More](https://flybefore.com/fpv/)

**RSSI**
Received signal strength indication. A measure of how strong the radio signal is at the receiver. [More](https://flybefore.com/fpv/)

**Link quality (LQ)**
The share of control packets that arrive correctly. Often a better warning of an impending failsafe than RSSI. [More](https://flybefore.com/fpv/)

**EdgeTX**
Open-source firmware for RC transmitters, used on RadioMaster, Jumper, BetaFPV and other radios. It grew out of OpenTX. [More](https://flybefore.com/controllers/radiomaster-edgetx/)

**USB joystick (HID)**
A USB mode in which a radio presents itself to the computer as a standard game controller. No driver is needed on macOS. [More](https://flybefore.com/controllers/)

**Maiden**
A plane&#x27;s first flight. [More](https://flybefore.com/guides/maiden-flight-checklist/)

**Dead-stick landing**
Landing with the motor stopped. A planned glide to the field is a standard skill to practice. [More](https://flybefore.com/learn/)

**Crosswind**
Wind blowing across the runway. Landings need a correction so the plane does not drift sideways. [More](https://flybefore.com/learn/)

**Thermal**
A column of rising warm air. Gliders and motor gliders use thermals to climb without power.

**Kv**
A brushless motor&#x27;s speed constant: unloaded rpm per volt. Higher Kv spins faster on the same battery and suits smaller props. [More](https://flybefore.com/workshop/)

**mAh**
Milliamp-hours, a battery&#x27;s capacity. A 2200 mAh pack can deliver 2.2 A for one hour, in theory.

**C rating**
A LiPo&#x27;s stated maximum continuous discharge as a multiple of its capacity. Manufacturer C ratings are often optimistic.

**ESC (electronic speed controller)**
Drives a brushless motor from the battery according to the throttle signal. Its current rating must exceed the motor&#x27;s maximum draw. [More](https://flybefore.com/workshop/)

Fly Before: RC Flight Simulator is a native macOS app (Apple Silicon) for flying RC planes and fixed-wing VTOLs that runs real ArduPilot in one click through the free ArduPilot Helper. One-time purchase, not on sale yet.

## Related

- [All guides](https://flybefore.com/guides/) 

- [ArduPilot on your Mac](https://flybefore.com/ardupilot/) 

- [Lessons](https://flybefore.com/learn/) 

## Sources

- ArduPilot Plane flight modes: [ardupilot.org/plane/docs/flight-modes.html](https://ardupilot.org/plane/docs/flight-modes.html) 

- ArduPilot QuadPlane: [ardupilot.org/plane/docs/quadplane-support.html](https://ardupilot.org/plane/docs/quadplane-support.html) 

- ArduPilot SITL: [ardupilot.org/dev/docs/sitl-simulator-software-in-the-loop.html](https://ardupilot.org/dev/docs/sitl-simulator-software-in-the-loop.html) 

- MAVLink: [mavlink.io](https://mavlink.io/en/); QGroundControl: [qgroundcontrol.com](https://qgroundcontrol.com/); EdgeTX: [edgetx.org](https://edgetx.org/)
